There are a few "gotchas" you should take into consideration, though, when it comes to powerline networking. Current adapters, however, adhere to the HomePlug AV2 standard, which uses the MIMO (multiple-input, multiple-output) technology to move many streams of data at once without getting bogged down. The first generation of powerline adapters could slow down your broadband considerably: They only allowed a single stream of data at once and topped out at a speed of 500Mbps. You then plug the other adapter into an outlet near your computer, connect it to your computer via an Ethernet cable and voila! Instant networking. All you do is connect one of the adapters to your router via an Ethernet cable, and plug it into a nearby AC outlet. Using a powerline kit is indeed about as easy as it gets. "That makes it the easiest way to liven up a networking dead zone or extend a LAN." "The beauty of powerline networking is that it is inexpensive, has reasonable range and doesn't require loading any software," says Jeff Heynen, research director at Infonetics, a telecommunications research firm. Or you can use a powerline kit, which routes data over your electric cables by piggybacking the data on top of the electrical current's 60-hertz wave and then extracting the data at the other end. You can try a Wi-Fi range extender (which might help, depending on the strength of your Wi-Fi and the efficiency of the extender). You can start drilling holes in your walls so you can run network cabling. If you have that problem, you have several options. Because of Wi-Fi's limited range - and old-school building construction techniques like thick plaster, brick or masonry walls - even the best Wi-Fi networks have dead zones. Are there places in your home or office where your Wi-Fi signal doesn't reach? You're not alone.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |